Centro-Matic® Automatic Lubrication Systems

Lincoln Centro-Matic® systems and components can service one machine, different zones on one machine or even several separate machines. Regardless of the application, the principle of centralized lubrication remains the same: a central pump station automatically delivers lubricant through a single supply line to the injectors. Each injector serves only one lubrication point and may be accurately adjusted to deliver the precise amount of grease or oil required.

More detail can be found in the Lincoln Centro-Matic automatic lubrication systems Catalogue

Centro-Matic® Injectors

Each Lincoln Centro-Matic injector can be manually adjusted to discharge the precise amount of lubricant each bearing needs. Injectors are mounted singly at each bearing, or grouped in a manifold with feedlines supplying lubricant to the bearings. In each case, injectors are supplied with lubricant under pump pressure through a single supply line. Two injector types are available: a top adjusting and a side adjusting. Both types can be used in the same circuit; their selection is made on the basis of bearing lubricant requirements.

Centro-Matic® Automatic Lubrication Systems FlowMaster II Pump

  • Increases pump life and simplifies pump installation, operation and service
  • Common crankcase design for all FlowMaster motors (hydraulic, AC or DC electric)
  • Less susceptible to grease contamination
  • Pump and reservoir combination models are level sensor and shut-off system ready

Centro-Matic® Automatic Lubrication Systems Manual Grease Pumps

Once you have determined your total lubricant requirements, your greatest line length and compensated for line expansion, you’re ready to determine the pump you need. If your overall requirements are less than 2.4 cu. in. for oil or 2.15 cu. in. for grease, you can select a single stroke pump. Should your requirements demand more capacity, a reciprocating pump will ill the need.

Centro-Matic® Automatic Lubrication Systems Manually Operated Oil Pump

Pump discharges lubricant on air-powered forward stroke and vents on spring-powered return stroke through built-in check/vent valve. Translucent reservoir is refilled through filler cap with strainer.

Centro-Matic® Automatic Lubrication Systems Air–Operated (Single Stroke) Oil Pumps